China Quality parts Professional Precision machining,Precision parts processing、Motor shaft, Bushings, rivets, special screws, nuts, etc.Precision partsProcessing. Products are widely used in automotive, communications, medical, watch, mobile phone, computer and other industries.
In the process of production and processing in the machinery industry, although some details are inconspicuous, if we can draw inspiration from them, we can make an analogy and use our brains and think of ways to help our work. To summarize the tips provided by a teacher in the mechanical processing industry for your reference. Tip 1: Remove the jaws of the vice, and process two M4 threaded holes, align the two steel plates 2 with a thickness of 1.5 mm flush with the jaws, and rivet a hard brass plate with a thickness of 0.8 mm with aluminum countersunk rivets 3 Fasten it to the jaws with M4 countersunk screws 1 to form a durable soft jaw. In this way, the hardware parts can be protected from being clipped, and they are interchangeable. Tip 2: It is inconvenient to suck and pick up small parts (expensive parts) with a magnet. You can suck an iron plate 2 under the magnet 1. Not only can you suck a lot of small parts, but also pull the iron plate away, the small parts will automatically Poured into the collection box is not enough to impress, but it is very practical. Tip 3: When the pulley is driving, the pulley often slips between the wheel and the axle. Use a ￠15~18mm dimple bit on the axle to draw a series of nests, which can form adsorption force, prevent slippage, and turn waste into treasure. The boss will reward. Tip four: When the handle of the hexagon socket wrench is short and cannot be stressed, the pipe with a slightly larger inner diameter than the wrench can be inserted into the groove from a section of the milling groove, which can be regarded as a long handle. Tip 5: There is a statement that the workpiece is first positioned and then clamped for tightening, but for a workpiece, first clamp and then position, because the workpiece will definitely be deformed during clamping, so it should be clamped and then positioned, for 6 points Orient and find the degrees of freedom that limit it. Most of the above tips and knocks are discovered by employees in their daily work. These tips can't really represent anything on the surface, but when you use more, you can bring many benefits to the company including yourself. I hope you will discover these tips and tricks in your work.
